ChamSys Ltd www.chamsys.co.uk
MagicQ User Manual 266 Version 1.4.9.0
30.1.1 Remote programming commands
Remote programming commands enable simple programming actions to be carried out from a remote
terminal. Remote programming commands consist of the program command number followed by
parameters and completed with an “H”.
The commands are:
<01> , <start head> , [<end head>] H Select one or more heads
<02> , <start head> , [<end head>] H Deselect one or more heads
<03> H Deselect all heads
<04> , <group number> H Select group
<05> , <level> , [<time>] H Set intensity of selected heads
<06> , <attribute number> , <value> , [<time>] H Set attribute value of selected heads
<07> , <attribute number> , <value> , [<16bit>] H Increase attribute of selected heads
<08> , <attribute number> , <value> , [<16bit>] H Decrease attribute of selected heads
<09> H Clear programmer
<10> , <palette id> H Include position palette
<11> , <palette id> H Include colour palette
<12> , <palette id> H Include beam palette
<13> , <cue id> H Include cue
<19> H Update
<20>, <palette id> H Record position palette
<21> , <palette id> H Record colour palette
<22> , <palette id> H Record beam palette
<23> , <cue id> H Record cue
<30> H Next head
<31> H Previous head
<32> H All heads
<40> H Locate
<41> H Lamp on
<42> H Lamp off
<43> H Reset
<80> , <cue id> H Test Cue
<81> , <cue id> H Untest Cue
<82> , <cue stack id> H Test Cue Stack
<83> , <cue stack id> H Untest Cue Stack
<90> , <showfile id> H Save show showXXXX.shw
<91> , <showfile id> H Load show showXXXX.shw
[] indicates an optional parameter
<level> is an integer between 0 and 100
<palette id> is an integer between 1 and 1024
<cue id> is an integer between 1 and 5000
<16 bit> is a flag. 0 for change in 8 bit resolution, 1 for change in 16 bit resolution
<time> is an integer time in seconds
<group number> is an integer between 1 and 200
<start head> and <end head> are integers between 1 and 6145
<showfile id> is a four digit decimal number between 0000 and 9999.
To Next Page
Loading...
