ChamSys Ltd www.chamsys.co.uk
MagicQ User Manual 135 Version 1.4.9.0
Normally when this setting is set to Yes, the settings Cue Stack is a Size Master and Cue stack is a Speed
Master should be set to No.
When this setting is set to No then the Cue Stack behaves normally.
16.3.2 Cue Stack is a Size Master
When this setting is set to Yes then the Cue Stack behaves as an FX Size Master. The Cue Stack normal
Cue execution behaviour is disabled.
The channels stored in the first Cue are used to determine which channels are under control of the
Intensity Master. The actual levels of the channels in the first Cue is not important – only that the
Channels have some level in the Cue.
In order for the Intensity Master to be activated the Go button must be pressed. To release the Intensity
Master the Playback must be selected and the REL button pressed. The Button settings “Flash activates
Stack” and “Flash releases Stack” are ignored. In order to avoid sudden changes in output level the fader
should be raised to 100% before activating or releasing.
When the fader is at 100% then FX size is as programmed. As the fader is lowered then the FX size is
reduced until it reaches zero size at 0%.
A particular channel can only be controlled from one FX Size Master.
Normally when this setting is set to Yes, the setting Cue Stack is an Intensity Master should be set to No.
It is possible to have a Cue Stack set to both a Size Master and a Speed Master.
When this setting is set to No then the Cue Stack behaves normally.
16.3.3 Cue Stack is a Speed Master
When this setting is set to Yes then the Cue Stack behaves as an FX Speed Master. The Cue Stack normal
Cue execution behaviour is disabled.
The channels stored in the first Cue are used to determine which channels are under control of the
Intensity Master. The actual levels of the channels in the first Cue is not important – only that the
Channels have some level in the Cue.
In order for the Intensity Master to be activated the Go button must be pressed. To release the Intensity
Master the Playback must be selected and the REL button pressed. The Button settings “Flash activates
Stack” and “Flash releases Stack” are ignored. In order to avoid sudden changes in output level the fader
should be raised to 100% before activating or releasing.
When the fader is at 100% then FX size is as programmed. As the fader is lowered then the FX size is
reduced until it reaches zero size at 0%.
A particular channel can only be controlled from one FX Speed Master.
Normally when this setting is set to Yes, the setting Cue Stack is an Intensity Master should be set to No.
It is possible to have a Cue Stack set to both a Size Master and a Speed Master.
When this setting is set to No then the Cue Stack behaves normally.
To Next Page
Loading...
