ChamSys Ltd www.chamsys.co.uk
MagicQ User Manual 182 Version 1.4.9.0
19.13.6 Serial data bits
Data bit sizes of 4,5,6,7 and 8 are supported.
19.13.7 Serial stop bits
MagicQ PC Supports 1,1.5 or 2 stop bits. MagicQ consoles support 1 or 2 stop bits.
19.13.8 Serial remote protocol
Determines what protocol is used on the serial port. If set to “none” then any data received is ignored. Data
can be transmitted from the Macro field of Cue steps in the Cue Stack.
The other protocols are:
ChamSys Rem (rx)
ChamSys Rem (tx & rx)
ChamSys Rem (tx)
Ideal Touch
A1 Touch
Elo Touch
The Touch protocols are for the use of external touch screens with the MQ50, MQ100, MQ200 and MQ300
consoles. Refer to the instruction manual of your touch screen for other serial settings.
See
Serial Communications
and
Multiple Consoles
for more details.
19.13.9 Serial touch monitor
Determines which monitor on the MagicQ system has a touch screen connected to the serial port. On a Pro
console with a serial touch screen connected to the 2
nd
Monitor port select “Monitor 2”. For a duplicate
monitor for the on-board screen select “Monitor 1 duplicate”. On a MQ50 select “Monitor 1”.
19.13.10 Remote trigger type
This setting specifies how the remote input port on MagicQ consoles, MagicQ PC Wings and MagicQ
Maxi Wings works.
It can be set to None, Make, Break, or Make + Break.
19.13.11 Remote trigger action
This setting specifies specific global actions to be taken on a remote trigger input. The options are:
The options are:
NONE
CURRENT PLAYBACK GO
CURRENT PLAYBACK FLASH
ADD/SWAP
SWAP
DBO
To Next Page
Loading...
Need help?
General
