D-Link DGS-1210/ME series - Show Address_Binding Dhcp_Pd_Snoop; Config Address_Binding Vlan

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
82
Success.
DGS-1210-28MP/ME:5#
show address_binding dhcp_pd_snoop
Purpose Used to display address binding DHCPv6 PD Snooping.
Syntax
show address_binding dhcp_pd_snoop {binding_entry | ports
<portlist>}
Description
This show address_binding dhcp_pd_snoop command is used to
display IP-MAC-port binding DHCPv6 PD snooping.
Parameters
None.
Restrictions None.
Example usage:
To display address binding DHCPv6 PD Snooping on the Switch:
DGS-1210-28MP/ME:5# show address_binding dhcp_pd_snoop binding_entry
Command: show address_binding dhcp_pd_snoop binding_entry
IP Address Port Lease Remain
--------------------------------------- ------- ---------- ------------
Total Entries : 0
DGS-1210-28MP/ME:5#
config address_binding vlan
Purpose Used to configure an IP-MAC-port binding specified VLAN.
Syntax
config address_binding vlan {<vidlist>} vlan_mode state
[enable | disable]
Description
The config address_binding vlan
command is used to configure
the IP-MAC-port binding for specified VLAN.
Parameters
{<vidlist>} − Specifies the VLAN ID to be configured.
[enable | disable] – Specifies to enable or disable the IP-MAC-port
binding of the specified VLAN.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To disable the address binding of VLAN ID 1on the Switch:
DGS-1210-28MP/ME:5# config address_binding vlan 1 vlan_mode state disable
Command: config address_binding vlan 1 vlan_mode state disable
Success.
DGS-1210-28MP/ME:5#