D-Link DGS-1210/ME series - Smtp Server Commands; Enable Smtp; Disable Smtp

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
38
6
SMTP SERVER COMMANDS
The SMTP Server commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable smtp
disable smtp
config smtp
[self_mail_addr <mail_addr 64> | server [<ipaddr> | <ipv6addr>] | server_port
<tcp_port_number 1-65535>] [{add mail_receiver <mail_addr 64>| delete
mail_receiver <index 1-8>}]
show smtp
smtp sent_testmsg
Each command is listed in detail, as follows:
enable smtp
Purpose To enable the SMTP server feature on the Switch.
Syntax
enable smtp
Description
The enable smtp
command enables the SMTP server feature on
the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this
command.
Example usage:
To enable SMTP feature on the Switch:
DGS-1210-28MP/ME:5# enable smtp
Command: enable smtp
Success.
DGS-1210-28MP/ME:5#
disable smtp
Purpose To disable the SMTP server feature on the Switch.
Syntax
disable smtp
Description
The disable smtp command disables the SMTP server feature on
the Switch.
Parameters None.
Restrictions Only Administrator and Operator-
level users can issue this
command.