D-Link DGS-1210/ME series - Disable Snmp Rstpport_State_Change Traps; Enable Snmp Duplicate_Ip_Detected Traps; Disable Snmp Duplicate_Ip_Detected Traps

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
119
DGS-1210-28MP/ME:5#
disable snmp rstpport_state_change traps
Purpose To disable SNMP RSTP port state change traps.
Syntax
disable snmp rstpport_state_change traps
Description
The disable snmp rstpport_state_change traps command
disables SNMP RSTP port state change traps on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable SNMP RSTP port state change traps support on the Switch:
DGS-1210-28MP/ME:5# disable snmp rstpport_state_change traps
Command: disable snmp rstpport_state_change traps
Success.
DGS-1210-28MP/ME:5#
enable snmp duplicate_IP_detected traps
Purpose To enable SNMP duplicate IP detected traps support on the Switch.
Syntax
enable snmp duplicate_IP_detected traps
Description
The enable snmp duplicate_IP_detected traps command enables
SNMP duplicate IP detected traps support on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable the SNMP duplicate_IP_detected traps on the Switch:
DGS-1210-28MP/ME:5# enable snmp duplicate_IP_detected traps
Command: enable snmp duplicate_IP_detected traps
Success.
DGS-1210-28MP/ME:5#
disable snmp duplicate_IP_detected traps
Purpose To disable SNMP duplicate IP detected traps support on the Switch.
Syntax
disable snmp duplicate_IP_detected traps
Description
The disable snmp duplicate_IP_detected traps command
disables SNMP duplicate IP detected traps support on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.