D-Link DGS-1210/ME series - Config Dhcp_Relay Delete Ipif System; Config Dhcp_Relay Hops

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
131
config dhcp_relay delete ipif System
Purpose To delete a DHCP server from the DHCP Relay server list.
Syntax
config dhcp_relay delete ipif System <ipaddr>
Description
The config dhcp_relay delete ipif System
command deletes a
DHCP servers defined as a DHCP Relay server.
Parameters
<ipaddr> − The IP address of the DHCP server.
Restrictions Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To remove a DHCP server from the DHCP Relay server list:
DGS-1210-28MP/ME:5# config dhcp_relay delete ipif System 10.6.150.49
Command: config dhcp_relay delete ipif System 10.6.150.49
Success.
DGS-1210-28MP/ME:5#
config dhcp_relay hops
Purpose To configure the maximum number of DHCP relay hops
that the
DHCP packets cross.
Syntax
config dhcp_relay hops <value 1-16>
Description
The config dhcp_relay hops command configures the maximum
number of DHCP relay hops that the DHCP packets cross.
Parameters
hops <value 1-16> − Specifies the maximum number of relay agent
hops that the DHCP packets can cross.
Restrictions Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To configure the DHCP relay hops on the Switch:
DGS-1210-28MP/ME:5# config dhcp_relay hops 12
Command: config dhcp_relay hops 12
Success.
DGS-1210-28MP/ME:5#