D-Link DGS-1210/ME series - Show Address_Binding Ip_Mac Log; Config Address_Binding Auto_Scan; Config Address_Binding Auto_Scan Ipv6 Address

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
76
Success.
DGS-1210-28MP/ME:5#
show address_binding ip_mac log
Purpose Used to display an IP-MAC-port binding IP MAC log information.
Syntax
show address_binding ip_mac log
Description
The show address_binding ip_mac log
command is used to
display an IP-MAC-port binding IP MAC log information.
Parameters None.
Restrictions None.
Example usage:
To display address binding IP MAC log information on the Switch:
DGS-1210-28MP/ME:5# show address_binding ip_mac log
Command: show address_binding ip_mac log
Log status: IPv4
DGS-1210-28MP/ME:5#
config address_binding auto_scan
Purpose Used to configure an IP-MAC-port binding auto scan for specified IP
addresses.
Syntax
config address_binding auto_scan from_ip <ipaddr> to_ip
<ipaddr>
Description
The config address_binding auto_scan
command is used to
configure the IP-MAC-port binding auto scan for specified IP
addresses.
Parameters
<ipaddr> −
Specifies a range of IP addresses for address binding
auto scan on the Switch.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To configure address binding auto scan on the Switch:
DGS-1210-28MP/ME:5# config address_binding auto_scan from_ip 10.0.0.10 to_ip
10.0.0.12
Command: config address_binding auto_scan from_ip 10.0.0.10 to_ip 10.0.0.12
Success.
DGS-1210-28MP/ME:5#
config address_binding auto_scan ipv6address
Purpose Used to configure an IP-MAC-port binding
auto scan for specified
IPv6 addresses.
Syntax
config address_binding auto_scan ipv6address from_ip