D-Link DGS-1210/ME series - Config Ddp Ports; Show Ddp

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
47
DGS-1210-28MP/ME:5# config ddp report timer 30
Command: config ddp report timer 30
Success.
DGS-1210-28MP/ME:5#
config ddp ports
Purpose To configure the ports of D-Link discover protocol packet report
state.
Syntax
config ddp ports [all | <portlist>] state [enable | disable]
Description
The config ddp ports command is used configure the D-Link
discover protocol packet report port state.
Parameters
[all | <portlist>] - Specifies the ports of D-Link Discover Protocol
state to be enabled or disabled.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To enable the ports 6-8 of D-Link discover protocol state:
DGS-1210-28MP/ME:5# config ddp ports 6-8 state enable
Command: config ddp ports 6-8 state enable
Success.
DGS-1210-28MP/ME:5#
show ddp
Purpose To display the ports of D-Link discover protocol packet information.
Syntax
show ddp
Description
The show ddp command is used to display the ports of D-Link
discover protocol packet information.
Parameters None.
Restrictions None.
Example usage:
To display the D-Link discover protocol state: