DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
467
DGS-1210-28MP/ME:5# config lldp reinit_delay 1
Command: config lldp reinit_delay 1
Success.
DGS-1210-28MP/ME:5#
config lldp tx_delay
Purpose To configure the lldp tx_delay on the switch.
Syntax
config lldp tx_delay <sec 1-8192>
Description
The config lldp tx_delay command specifies the delay between
successive LLDP frame transmissions initiated by value/status
changes in the LLDP local systems MIB, use the lldp tx_delay
command in global configuration mode.
Parameters
<sec 1-8192> – Specifies the minimum time in seconds an LLDP
port will wait before reinitializing LLDP transmission. The range is
1 – 8192 seconds. The default configuration is 2 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP tx delay:
DGS-1210-28MP/ME:5# config lldp tx_delay 1
Command: config lldp tx_delay 1
Success.
DGS-1210-28MP/ME:5#
config lldp notification_interval
Purpose To configure the timer of the notification interval used to send
notifications to configured SNMP trap receiver(s).
Syntax
config lldp notification_interval <sec 5-3600>
Description
The config lldp notification_interval command globally changes
the interval between successive LLDP change notifications
generated by the switch.
Parameters
<sec 5-3600> – The range is from 5 second to 3600 seconds. The
default setting is 5 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To change the notification interval:
To Next Page
Loading...
