D-Link DGS-1210/ME series - Show Port Dot1 V; Show Gvrp

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
269
show port dot1v
Purpose To display the VLAN to be associated with untagged packets
ingressed from a port based on the protocol group.
Syntax
show port dot1v {ports <portlist>}
Description
The show port dot1v command is used to display the VLAN to be
associated with untagged packets ingressed from a port based on
the protocol group.
Parameters
ports <portlist> − Specify a range of ports to be displayed. If not
specified, information for all ports will be displayed.
Restrictions
None.
Example usage:
To display the protocol VLAN information for ports 1 to 2:
DGS-1210-28MP/ME:5# show port dot1v ports 1-2
Command: show port dot1v ports 1-2
Port: 1
No valid dot1v entry!
Port: 2
No valid dot1v entry!
Total Entries: 0
DGS-1210-28MP/ME:5#
show gvrp
Purpose To display the GVRP status for a port list or port channel
on the
Switch.
Syntax
show gvrp {<portlist>}
Description
The show gvrp command displays the GVRP status for a port list or
a port channel on the Switch.
Parameters
<portlist> − Specifies a port or range of ports for which the GVRP
status is to be displayed.
Restrictions None.
Example usage:
To display GVRP port 5~8 status:
DGS-1210-28MP/ME:5# show gvrp 5-8
Command: show gvrp 5-8
Global GVRP : Enable
Port PVID GVRP State Ingress Checking Acceptable Frame Type
---- ---- ---------- ----------------------- ---------------------------------