DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
404
To delete the sFlow sampler the rate of port 1 to be 0:
DGS-1210-28MP/ME:5# delete sflow flow_sampler ports all
Command: delete sflow flow_sampler ports all
Success.
DGS-1210-28MP/ME:5#
show sflow flow_sampler
Purpose
Used to show the sFlow flow sampler configured for ports. The
actual value rate is 256 times the displayed rate value. There are
two types of rates. The Configured Rate is configured by the user. In
order to limit the number of packets sent to the CPU when the rate
of traffic to the CPU is high, the sampling rate will be decreased.
This is specified as the active rate.
Syntax
show sflow flow_sampler
Description
The show sflow flow_sampler command is used to show the
sFlow flow sampler configured for ports.
Parameters None.
Restrictions None.
Example usage:
To show the sFlow flow sampler information of ports which have been created:
DGS-1210-28MP/ME:5# show sflow flow_sampler
Command: show sflow flow_sampler
Port Analyzer Configured Configured Active Active Max Header
Server ID Rx Rate Tx Rate Rx Rate Tx Rate Size
------- -------------- --------------- ---------------- ---------- ------------- ------------------
Total Entries: 0
DGS-1210-28MP/ME:5#
To Next Page
Loading...
