D-Link DGS-1210/ME series - Delete Snmp Group

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
97
adds:
• Message integrity − Ensures that packets have not been
tampered with during transit.
• Authentication − Determines if an SNMP message is from a
valid source.
• Encryption − Scrambles the contents of messages to
prevent it from being viewed by an unauthorized source.
noauth_nopriv − Specifies that there is
no authorization and no
encryption of packets sent between the Switch and a remote SNMP
manager.
auth_nopriv − Specifies that authorization is required, but there is no
encryption of packets sent between the Switch and a remote SNMP
manager.
auth_priv − Specifies that authorization is required, and that packets
sent between the Switch and a remote SNMP manger are
encrypted.
read_view –
Specifies that the SNMP group being created can
request SNMP messages.
• <view_name 32> − A string of up to 32 objects that a remote
SNMP manager is allowed to access on the Switch.
write_view – Specifies that the SNMP group being created has write
privileges.
• <view_name 32 identifies
the group of MIB objects that a
remote SNMP manager is allowed to access on the Switch.
notify_view − Specifies that the SNMP group being created can
receive SNMP trap messages generated by the Switch’s SNMP
agent.
• <view_name 32> − A string of up to 32 alphanumeric
characters that identifies the group of MIB ob
jects that a
remote SNMP manager is allowed to access on the Switch.
Restrictions Only administrator, operate or power user-level users can issue this
command.
Example usage:
To create an SNMP group named ‘sg1:’
DGS-1210-28MP/ME:5# create snmp group sg1 v2c read_view sg1 write_view sg1
notify_view sg1
Command: create snmp group sg1 v2c read_view sg1 write_view sg1 notify_view
sg1
Success.
DGS-1210-28MP/ME:5#
delete snmp group
Purpose To remove an SNMP group from the Switch.
Syntax
delete snmp group <groupname 32> [v1 | v2c | v3 [auth_priv |
noauth_nopriv]]
Description
The delete snmp group command removes an SNMP group from
the Switch.
Parameters
<groupname 32> − A string of that identifies
the SNMP group the
new SNMP user will be associated with. Up to 32 alphanumeric