DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
28
used as the packets’ source IPv6 address that ping6 sends to the
remote host.
timeout <sec 1-99> - The time-
out period while waiting for a
response from the remote device. A value of 1 to 99 seconds can be
specified. The default is 1 second.
times <value 1-255> -
The number of individual ICMP echo
messages to be sent. The maximum value is 255. The default is 4.
Restrictions None.
Example usage:
To ping the IPv6 address to “3000::1” four times:
DGS-1210-28MP/ME:5# ping6 3000::1 times 4
Command: ping6 3000::1 times 4
Reply From : 3000::1, bytes=200, time<10ms
Reply From : 3000::1, bytes=200, time<10ms
Reply From : 3000::1, bytes=200, time<10ms
Reply From : 3000::1, bytes=200, time<10ms
--- 3000::1 Ping Statistics ---
4 Packets Transmitted, 4 Packets Received, 0% Packets Loss
DGS-1210-28MP/ME:5#
traceroute
Purpose
The traceroute User EXEC mode command discovers routes that
packets actually take when traveling to their destination.
Syntax
traceroute <ip_addr> {[max-ttl <short 1-99> | min-ttl <short 1-
99>}
Description
The traceroute command
discovers routes that packets actually
take when traveling to their destination.
Parameters
<ip_addr> - Specifies the IP address of the destination host.
max-ttl <short 1-99> -
The largest TTL value that can be used.
The traceroute command terminates when the
reached or when this value is reached.
min-ttl <short 1-99> -
The smallest TTL value that can be used.
The traceroute command terminates when the
reached or when this value is reached.
Restrictions Only Administrator or operate-level users can issue this command.
Example usage:
To trace route IP 10.90.90.92 with max-ttl is 10:
DGS-1210-28MP/ME:5# traceroute 10.90.90.92 max-ttl 10
Command: traceroute 10.90.90.92 max-ttl 10
Tracing Route to 10.90.90.92 with 10 hops max and 1 byte packets
[!N - Network Unreachable !H - Host Unreachable !P - Protocol Unreachable]
1 0.0.0.0 * * *
2 0.0.0.0 * * *
To Next Page
Loading...
