D-Link DGS-1210/ME series - Show Private_Vlan; Config Gvrp

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
263
Success.
DGS-1210-28MP/ME:5#
show private_vlan
Purpose To display private VLAN information on the Swtich.
Syntax
show private_vlan {vlan <vlan_name 32> | vlanid <vlanid_list>}
Description
The show private_vlan command is used to display private VLAN
information on the Swtich.
Parameters
<vlan_name 32> − Specifies the name of the private VLAN to be
displayed.
vlanid <vlanid_list> − Specifies the VLAN ID of the private VLAN to
be displayed.
Restrictions Only Administrator and Operator and Power-User-
level users can
issue this command.
Example usage:
To display the private VLAN information for VLAN ID 2:
DGS-1210-28MP/ME:5# show private_vlan vlanid 2
Command: show private_vlan vlanid 2
Primary Vlan ID: 2
------------------------------------------
Promiscuous Ports :
Community Ports : 1-28 Community VLAN: 1
Total Entries : 1
DGS-1210-28MP/ME:5#
config gvrp
Purpose To configure
configures the Group VLAN Registration Protocol on
the Switch. The user can configure ingress checking and acceptable
frame tagged only, the sending and receiving of GVRP information,
and the Port VLAN ID (PVID).
Syntax
config gvrp [<portlist> | all] [state [enable | disable] |
ingress_checking [enable | disable] | acceptable_frame
[Tagged_Only | All_Frames] | pvid <vlanid 1-4094>]
Description
The config gvrp command configures the Group VLAN Registration
Protocol on the Switch. The user can configure ingress checking and
acceptable frame tagged only, the sending and receiving of GVRP
information, and the Port VLAN ID (PVID).
Parameters
<portlist> − A port or range of ports for which to configure GVRP.
all − configure GVRP on ports.
state [enable | disable] - enable and disable GVRP
ingress_checking [enable | disable] − Enables or disables ingress