DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
296
delete ipif
Purpose To delete an IP interface on the switch.
Syntax
delete ipif [<ipif_name 12> | all]
Description
The delete ipif command will delete an IP interface.
Parameters
[<ipif_name 12> | all] -
Specifies the IP interface name or all IP
interface to be deleted.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To delete an IP interface:
DGS-1210-28MP/ME:5# delete ipif all
Command: delete ipif all
Success.
DGS-1210-28MP/ME:5#
enable ipif
Purpose To enable an IP interface on the switch.
Syntax
enable ipif [<ipif_name 12> | all]
Description
The enable ipif command will create an IP interface.
Parameters
[<ipif_name 12> | all] -
Specifies the IP interface name or all IP
interface to be enabled.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable all IP interface:
DGS-1210-28MP/ME:5# enable ipif all
Command: enable ipif all
Success.
DGS-1210-28MP/ME:5#
disable ipif
Purpose To disable an IP interface on the switch.
Syntax
disable ipif [<ipif_name 12> | all]
Description
The disable ipif command will create an IP interface.
Parameters
[<ipif_name 12> | all] -
Specifies the IP interface name or all IP
interface to be disabled.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable all IP interface:
DGS-1210-28MP/ME:5# disable ipif all
Command: disable ipif all
To Next Page
Loading...
