D-Link DGS-1210/ME series - Enable Address_Binding Roaming; Disable Address_Binding Roaming; Show Address_Binding Roaming

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
83
enable address_binding roaming
Purpose Used to enable address binding roaming.
Syntax
enable address_binding roaming
Description
This enable address_binding roaming command is used to enable
IP-MAC-port binding roaming.
Parameters None.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To enable the roaming of address binding on the Switch:
DGS-1210-28/ME:5# enable address_binding roaming
Command: enable address_binding roaming
Success.
DES-1210-52/ME:5#
disable address_binding roaming
Purpose Used to disable address binding roaming.
Syntax
disable address_binding roaming
Description
This disable address_binding roaming
command is used to
disable IP-MAC-port binding roaming.
Parameters None.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To disable the roaming of address binding on the Switch:
DGS-1210-28/ME:5# disable address_binding roaming
Command: disable address_binding roaming
Success.
DES-1210-52/ME:5#
show address_binding roaming
Purpose Used to display DHCP snoop of IP-MAC-port binding lroaming
information.
Syntax
show address_binding roaming
Description
This show address_binding roaming command is used to display
DHCP snoop of IP-MAC-port binding roaming information.
Parameters None.
Restrictions None.
Example usage:
To display DHCP snoop of address binding roaming information on the Switch:
DGS-1210-28/ME:5# show address_binding roaming