D-Link DGS-1210/ME series - Disable Snmp Port_Security_Violation Traps; Enable Snmp Rstpport_State_Change Traps

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
118
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable SNMP port security violation traps support on the Switch:
DGS-1210-28MP/ME:5# enable snmp port_security_violation traps
Command: enable snmp port_security_violation traps
Success.
DGS-1210-28MP/ME:5#
disable snmp port_security_violation traps
Purpose To disable SNMP port security violation traps.
Syntax
disable snmp port_security_violation traps
Description
The disable snmp port_security_violation traps command
disables SNMP port security violation traps on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable SNMP port security violation traps support on the Switch:
DGS-1210-28MP/ME:5# disable snmp port_security_violation traps
Command: disable snmp port_security_violation traps
Success.
DGS-1210-28MP/ME:5#
enable snmp rstpport_state_change traps
Purpose To enable SNMP rstp port state change traps support on the Switch.
Syntax
enable snmp rstpport_state_change traps
Description
The enable snmp rstpport_state_change traps command enables
SNMP rstp port state change traps support on the Switch. After
enables the SNMP RSTP port state change traps support, the
Switch will send out a trap when the state of RSTP port is changed.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable SNMP RSTP port state change traps support on the Switch:
DGS-1210-28MP/ME:5# enable snmp rstpport_state_change traps
Command: enable snmp rstpport_state_change traps
Success.