D-Link DGS-1210/ME series - Config Snmp Linkchange_Traps Ports; Show Snmp Traps Linkchange_Traps

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
109
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable the SNMP link change trap function:
DGS-1210-28MP/ME:5# disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DGS-1210-28MP/ME:5#
config snmp linkchange_traps ports
Purpose To configure SNMP traps support on the Switch.
Syntax
config snmp linkchange_traps ports [<portlist> | all] [enable |
disable]
Description
The config snmp linkchange_traps ports command configures
the SNMP trap support status currently configured on the Switch.
Parameters
[<portlist> | all] –
Specifies a port, ports or port range to be
configured.
[enable | disable] – Enable or disable the SNMP trap support for
specified port.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the current SNMP trap settings:
DGS-1210-28MP/ME:5# config snmp linkchange_traps ports all enable
Command: config snmp linkchange_traps ports all enable
Success.
DGS-1210-28MP/ME:5#
show snmp traps linkchange_traps
Purpose To show SNMP traps support on the Switch.
Syntax
show snmp traps linkchange_traps
Description
The show snmp traps command displays the SNMP trap support
status currently configured on the Switch.
Parameters None.
Restrictions None.
Example usage:
To view the current SNMP trap support:
DGS-1210-28MP/ME:5# show snmp traps linkchange_traps
Command: show snmp traps linkchange_traps