D-Link DGS-1210/ME series - Smtp Sent_Testmsg

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
40
Syntax
show smtp
Description
The show smtp command displays the SMTP server settings on the
Switch.
Parameters None.
Restrictions None.
Example usage:
To display SMTP information on the Switch:
DGS-1210-28MP/ME:5# show smtp
Command: show smtp
smtp status : Enable
smtp server address : 0.0.0.0
smtp server port : 25
self mail address : dlink@mail.com.tw
Index Mail Receiver Address
-------- --------------------------------------
1
2
3
4
5
6
7
8
DGS-1210-28MP/ME:5#
smtp sent_testmsg
Purpose To
send test messages to all mail recipients configured on the
Switch.
Syntax
smtp sent_testmsg
Description
The smtp sent_testmsg command is used to send test messages
to all mail recipients configured on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-
level users can issue this
command.
Example usage:
To send SMTP test message to all mail receivers:
DGS-1210-28MP/ME:5# smtp sent_testmsg
Command: smtp sent_testmsg
Subject: This is a SMTP test
Content: Hello everybody!!