D-Link DGS-1210/ME series - Show 802.1 X Auth_Configuration

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
370
DGS-1210-28MP/ME:5# show 802.1x auth_state ports 1-5
Command: show 802.1x auth_state ports 1-5
Port Auth PAE State Backend State Port Status
------ ---------------------- -------------------- ---------------
1 ForceAuth Success Authorized
2 ForceAuth Success Authorized
3 ForceAuth Success Authorized
4 ForceAuth Success Authorized
5 ForceAuth Success Authorized
DGS-1210-28MP/ME:5#
show 802.1x auth_configuration
Purpose To display the current configuration of the 802.1x server on the
Switch.
Syntax
show 802.1x auth_configuration {ports <portlist>}
Description
The show 802.1x auth_configuration command displays the
current configuration of the 802.1x Port-
based Network Access
Control server application on the Switch.
The following details are displayed:
802.1x: Enabled/Disabled − Shows the current status of 802.1x
functions on the Switch.
Authentication Mode: Port-based/Mac-based/None − Shows the
802.1x authorization mode.
Authentication Method: Remote/none − Shows the
type of
auth
entication protocol suite in use between the Switch and a
RADIUS server.
Port number : Shows the physical port number on the Switch.
AdminCrlDir: Both/In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
OpenCrlDir: Both/In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
Port Control: ForceAuth/ForceUnauth/Auto − Shows the
administrative control over the port’s authorization status. ForceAuth
forces the Authenticator of the port to become Authorized.
ForceUnauth forces the port to become Unauthorized.
QuietPeriod : Shows the time interval between authentication failure
and the start of a new authentication attempt.
TxPeriod : Shows the time to wait for a response from a supplicant
(user) to send EAP Request/Identity packets.
SuppTimeout : Shows the time to wait for
a response from a
supplicant (user) for all EAP packets, except for the Request/Identity
packets.
ServerTimeout :
Shows the length of time to wait for a response
from a RADIUS server.
MaxReq :
Shows the maximum number of times to retry sending
packets to the supplicant.
ReAuthPeriod : Shows the time interval between successive