D-Link DGS-1210/ME series - Config Poe System; Show Poe Ports

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
168
Success!
Success!
Success!
DGS-1210-28MP/ME:5#
config poe system
Purpose Used to configure the Power over Ethernet (PoE) functionality.
Syntax
config
poe system [legacy_pd [enable | disable] |
power_disconnect_method [deny_low_priority_port |
deny_next_port] | power_limit <value 7-193>]
Description The config poe system configures the Po
wer over Ethernet (PoE)
functionality of the Switch.
Parameters
legacy_pd [enable | disable] −If the legacy pd is enabled, it will be
classified to non_AF PD or Legacy PD.
[deny_low_priority_port | deny_next_port] – Defines the method
used to deny power to a port once the threshold is reached. The
possible fields are:
Deny next port: When the pow
er budget is exceeded, the
next port attempting to power up is denied, regardless of the
port priority.
Deny low priority port: The port with the lower priority will be
shut down to allow the higher priority port to power up.
power_limit <value 7-193> - Configure the system power budget 7.1
~ 193.0 watts.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure PoE with ports 8-10:
DGS-1210-28MP/ME:5# config poe system power_limit 193
Command: config poe system power_limit 193
Success!
DGS-1210-28MP/ME:5#
show poe ports
Purpose Used to display the ports of Power over Ethernet (PoE).
Syntax
show poe ports [all | <portlist>]