D-Link DGS-1210/ME series - Power Saving Commands; Config Power_Saving Mode; Config Power_Saving

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
148
19 1
POWER SAVING COMMANDS
The Power Saving commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config power_saving
mode
[hibernation | led | link_detection | port] [enable | disable]
config power_saving
[hibernation | led [all | <portlist>] | port [all | <portlist>]] [add | delete] time_range1
<range_name 20> time_range2 <range_name 20> {clear_time_range}
show power_saving {hibernation | led | length_detection | port}
Each command is listed in detail, as follows:
config power_saving mode
Purpose To configure the power saving mode on the switch.
Syntax
config power_saving mode [hibernation | led | link_detection |
port] [enable | disable]
Description
The config power_saving mode command is used to configure the
power saving mode on the switch.
Parameters
hibernation – Configure the hibernation state to enable or disable.
The default value is disabled.
led – Configure the led state to enable or disable. The default value
is disabled.
link_detection – Configure the link detection state to enable or
disable. The default value is disabled.
port – Configure ports state to be enabled or disabled.
[enable | disable] – Enable or disable the power saving feature.
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To configure the power saving mode on the switch:
DGS-1210-28MP/ME:5# config power_saving mode port hibernation enable
Command: config power_saving mode port hibernation enable
Success.
DGS-1210-28MP/ME:5#
config power_saving
Purpose To configure the power saving on the switch.
Syntax
config power_saving [hibernation | led [all | <portlist>] | port [all