D-Link DGS-1210/ME series - Create Authen_Login Method_List_Name

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
436
Command Parameter
ipv6address <ipv6addr>] protocol [radius | tacacs+]
delete authen server_group <string 15>
show authen server_group {<string 15>}
enable admin
config admin local_enable
config accounting
[default | method_list_name <string 15>] method {tacacs+ | radius |
server_group <string 15> | none}
config accounting service
[network | shell | system] state [enable {[radius_only |
method_list_name <string 15> | default_method_list]} | disable]
config accounting service
command
{administrator | operator | power_user | user} [method_list_name
<string> | none]
create accounting
method_list_name
<string 15>
delete accounting
method_list_name
<string 15>
show accounting
[all | default | method_list_name <string 15>]
enable
aaa_server_password_encryption
disable
aaa_server_password_encryption
show aaa
Each command is listed in detail, as follows:
create authen_login method_list_name
Purpose To create a user-defined list of authentication methods for users
logging on to the Switch.
Syntax
create authen_login method_list_name <string 15>
Description
The create authen_login method_list_name command creates a
list of authentication techniques for user login. The Switch can
support up to eight method lists, but one is reserved as a default and
cannot be deleted. Multiple method lists must be created and
configured separately.
Parameters
<string 15> - Defines the method_list_name to be created as a string
of up to 15 alphanumeric characters.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To create the method list ‘Trinity’.