D-Link DGS-1210/ME series - Config Autoconfig; Show Autoconfig; Save

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
22
DGS-1210-28MP/ME:5#
config autoconfig
Purpose Use to configure the auto configuration timeout time from DHCP.
Syntax
config autoconfig timeout <value 1-65535>
Description
The config autoconfig command is used to the auto configuration
timeout time from DHCP.
Parameters
timeout <value 1-65535> - Specifies the timeout time. And the value
is from 1 to 65535 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the auto configuration timeout time to 100 seconds:
DGS-1210-28MP/ME:5# config autoconfig timeout 100
Command: config autoconfig timeout 100
Success.
DGS-1210-28MP/ME:5#
show autoconfig
Purpose Used to display the current autoconfig status of the Switch.
Syntax
show autoconfig
Description
The show autoconfig command is used to list the current status of
the auto configuration function.
Parameters None.
Restrictions None.
Example usage:
To display the autoconfig status:
DGS-1210-28MP/ME:5# show autoconfig
Command: show autoconfig
Autoconfig State : Enabled
Timeout : 50 sec
DGS-1210-28MP/ME:5#
save
Purpose To save changes in the Switch’s configuration to non-volatile RAM.
Syntax
save {[config config_id <value 1-2> | log]}
Description
The save command
used to enter the current switch configuration
into non-volatile RAM. The saved switch configuration will be loaded
into the Switch’s memory each time the Switch is restarted.