D-Link DGS-1210/ME series - Config Vlan_Auto_Learn; Show Vlan_Auto_Learn

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
276
<macmask 000000000000-ffffffffffff> - Specifies the MAC mask to be
displayed.
<vlan_name 32> - Specifies the VLAN name.
<vlanid 1-4094> - Specifies the VLAN id.
Restrictions
None.
Example usage:
To display the static or dynamic MAC-based VLAN entry:
DGS-1210-28MP/ME:5# show mac_based_vlan mac_address 00-00-00-11-22-33
Command: show mac_based_vlan mac_address 00-00-00-11-22-33
MAC Address MAC Address Mask VLAN ID Status Type
------------------------ ------------------------------ -------------- ---------- --------
00-00-00-11-22-33 FF-FF-FF-FF-FF-FF 1 Active Static
Total Entries : 1
DGS-1210-28MP/ME:5#
config vlan_auto_learn
Purpose To configure MAC address autolearning on a VLAN to be enabled or
disabled.
Syntax
config vlan_auto_learn vlanid <vidlist> [enable | disable]
Description
This config vlan_auto_learn command is used to configure MAC
address autolearning on a VLAN to be enabled or disabled.
Parameters
<vidlist> - Specifies the VLAN id to be configured.
Restrictions
Only Administrator and Operator and Power-User-level users can
issue this command.
Example usage:
To enable the VLAN ID 1of MAC address autolearning to be enabled:
DGS-1210-28MP/ME:5# config vlan_auto_learn vlanid 1 enable
Command: config vlan_auto_learn vlanid 1 enable
Success.
DGS-1210-28MP/ME:5#
show vlan_auto_learn
Purpose To display the MAC address autolearning state of a VLAN on the
Switch.
Syntax
show vlan_auto_learn vlanid [all | vlanid <vidlist>]
Description
This show vlan_auto_learn command is used to display the MAC
address autolearning state of a VLAN on the Switch.
Parameters
all | vlanid <vidlist> - Specifies all VLANs or VLAN id to be displayed.
Restrictions
None.