D-Link DGS-1210/ME series - Switch Port Commands; Config Ports

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
49
9
SWITCH PORT COMMANDS
The Switch Port commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config ports
[all | <portlist>] mdix [cross | normal | auto] {clear_description | description <desc
64> | flow_control [enable | disable] | learning [enable | disable] | state [enable |
disable] | speed [auto | 10G | 1000_full | 100_full | 100_half | 10_full | 10_half]
[auto_downgrade [enabe | disable]]}
config ports
[all | <portlist>] capability_advertised [1000_full | 100_full | 100_half | 10_full |
10_half | 10G_full] {[1000_full | 100_full | 100_half | 10_full | 10_half]}
show ports {<portlist> | all} {[description | err_disabled]}
show ports {<portlist> | all} [auto_negotiation | media_type | linkup_time]
show ports
{<portlist> | all} configuration [all | [{802.1x} {access_profile} {address_binding}
{bandwidth_multicast_address} {dhcp_local_relay} {dhcp_relay}
{limited_multicast_address} {link_aggregation} {loopdetect} {port_security} {ports}
{pppoe_cirquit_id_insertion} {stp} {traffic_control} {traffic_segmentation} {vlan}]]
delete ports [<portlist> | all] {medium_type [copper | fiber]} description
Each command is listed in detail, as follows:
config ports
Purpose To configure the Switch’s Ethernet port settings.
Syntax
config ports [all | <portlist>] mdix [cross | normal | auto]
{clear_description | description <desc 32> | flow_control
[enable | disable] | learning [enable | disable] | state [enable |
disable] | speed [auto | 10G_full | 1000_full | 100_full | 100_half |
10_full | 10_half]}
Description
The config ports command configures the Switch’s Ethernet port
settings. Only the ports listed in the <portlist> are affected.
Parameters
<portlist> − A port or range of ports to be configured.
all − Configures all ports on the Switch.
mdix [cross | normal | auto] − Specifies the MDIX setting of the port.
The MDIX setting can be auto, normal or cross.
If set to normal state, the port in MDIX mode, can be connected to
PC NIC using a straight cable. If set to cross state, the port in mdi
mode, can be connected to a port (in mdix mode) on another switch
through a straight cable.
clear_description − Clear the description of selected port.
description <desc 64> − Enter and alphanumeric string of no more
that 64 characters to DGScribe a selected port interface.
flow_control [enable] – Enables flow control for the specified ports.
flow_control [disable] – Disables flow control for the specified ports.