D-Link DGS-1210/ME series - Show Pppoe Circuit_Id_Insertion Ports

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
63
Switch.
Syntax
show pppoe circuit_id_insertion
Description
The show pppoe circuit_id_insertion command is used to display
the global state configuration of the PPPoE circuit ID insertion
function.
Parameters None.
Restrictions None.
Example usage:
To view the global PPPoE ID insertion state:
DGS-1210-28MP/ME:5# show pppoe circuit_id_insertion
Command: show pppoe circuit_id_insertion
Status: Enabled
DGS-1210-28MP/ME:5#
show pppoe circuit_id_insertion ports
Purpose Used to display the PPPoE ID insertion configuration on a per
port basis.
Syntax
show pppoe circuit_id_insertion ports {<portlist>}
Description
The show pppoe circuit_id_insertion ports command allows
the user to view the configuration of PPPoE ID insertion for each
port.
Parameters
<portlist> -Specifies which po
rts to display. If no ports are
specified, all ports configuration will be listed.
Restrictions None.
Example usage:
To view the PPPoE circuit ID configuration for ports 1 to 3:
DGS-1210-28MP/ME:5# show pppoe circuit_id_insertion ports 1-3
Command: show pppoe circuit_id_insertion ports 1-3
Port State PPPoE Tags
------ ------------ ---------------------------------------------
1 Enabled Circuit ID : UDF String (343)
Remote ID : Default
2 Enabled Circuit ID : UDF String (343)
Remote ID : Default
3 Enabled Circuit ID : UDF String (343)
Remote ID : Default
DGS-1210-28MP/ME:5#