D-Link DGS-1210/ME series - Delete Cos Ip_Mapping; Config Cos Ipv6_Mapping; Show Cos Ipv6_Mapping

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
203
delete cos ip_mapping
Purpose To remove the CoS IP mapping method.
Syntax
delete cos ip_mapping destination_ip <ipaddr>
Description
The delete cos ip_mapping command is used to delete the CoS IP
mapping method on the Switch.
Parameters
<ipaddr> - Specifies the IP address to be removed.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To delete the CoS ip mapping on the Switch:
DGS-1210-28MP/ME:5# delete cos ip_mapping destination_ip 10.0.0.56
Command: delete cos ip_mapping destination_ip 10.0.0.56
Success.
DGS-1210-28MP/ME:5#
config cos ipv6_mapping
Purpose To configure the CoS IPv6 mapping method.
Syntax
config cos ipv6_mapping destination_ipv6 <ipv6addr> class
<class_id 0-7>
Description
The config cos ipv6_mapping command is used to configure the
CoS IPv6 mapping method on the Switch.
Parameters
<iv6paddr> - Specifies the IPv6 address to be mapped. For
example, 3000::1.
<class_id 0-7> - Specifies
the number of the Switch’s hardware
priority queue.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure the CoS IPv6 mapping on the Switch:
DGS-1210-28MP/ME:5# config cos ipv6_mapping destination_ipv6 3000::1 class 1
Command: config cos ipv6_mapping destination_ipv6 3000::1 class 1
Success.
DGS-1210-28MP/ME:5#
show cos ipv6_mapping
Purpose To display the CoS IPv6 mapping method.
Syntax
show cos ipv6_mapping {destination_ipv6 <ipv6addr>}
Description
The show cos ipv6_mapping command is used to display the CoS
MAC mapping method on the Switch.