D-Link DGS-1210/ME series - Show Mac_Based_Access_Control Auth_State Ports; Delete Mac_Based_Access_Control_Local

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
284
Command: show mac_based_access_control_local
ID : 1
MAC Address : 00-11-22-33-44-55
Vlan ID : 1
Success.
DGS-1210-28MP/ME:5#
show mac_based_access_control auth_state ports
Purpose To display mac_based_access_control authentication status.
Syntax
show mac_based_access_control_local auth_state ports
[<portlist> | all]
Description
The show mac_based_access_control_local auth_state ports
command is used to display mac_based_access_control
authentication status.
Parameters
[<portlist> | all] – Specifies a range of ports or all ports to be
displayed the MAC-based Access Control port state.
Restrictions None.
Example usage:
To display mac based access control auth state:
DGS-1210-28MP/ME:5# show mac_based_access_control auth_state ports 1-28
Command: show mac_based_access_control auth_state ports 1-28
Empty Entry
Success.
DGS-1210-28MP/ME:5#
delete mac_based_access_control_local
Purpose To delete the local database entry.
Syntax
delete mac_based_access_control_local mac_address
<mac_addr> vlanid <int 1-4094>
Description
The delete mac_based_access_control_local command is used
to delete the local database entry.
Parameters
<mac_addr> - .Specifies MAC address that accesses accept by
local mode.
vlanid <int 1-4094> - Specifies the MAC address of the specified
VLAN ID to be deleted.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To delete the local database entry by mac address with VLAN id 2: