D-Link DGS-1210/ME series - Config Snmp Engineid; Show Snmp Engineid

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
94
strings that are configured on the Switch.
Parameters
<community_string 32> −
A string of up to 20 alphanumeric
characters that is used to identify members of an SNMP community.
This string is used like a password to give remote SNMP managers
access to MIB objects in the Switch’s SNMP agent.
Restrictions None.
Example usage:
To display the currently entered SNMP community strings:
DGS-1210-28MP/ME:5# show snmp community
Command: show snmp community
SNMP Community Table
(Maximum Entries : 10)
Community Name User Name
------------------------ ------------
public ReadOnly
private ReadWrite
Total Entries: 2
DGS-1210-28MP/ME:5#
config snmp engineID
Purpose To configure a name for the SNMP engine on the Switch.
Syntax
config snmp engineID <snmp_engineID 64>
Description
The config snmp engineID
command configures a name for the
SNMP engine on the Switch.
Parameters
<snmp_engineID 64> − A string, of between 10 and 64
alphanumeric characters, to be used to identify the SNMP engine on
the Switch.
Restrictions Only administrator, operate or power user-level users can issue this
command.
Example usage:
To give the SNMP agent on the Switch:
DGS-1210-28MP/ME:5# config snmp engineID 12345678900
Command: config snmp engineID 12345678900
Success.
DGS-1210-28MP/ME:5#
show snmp engineID
Purpose To display the identification of the SNMP engine on the Switch.