D-Link DGS-1210/ME series - Clear Mld_Snooping Data_Driven_Group; Show Mld_Snooping

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
355
lifetime, in seconds. The value is between 130 and 1530255.
state [enable | disable] –Specify to enable or disable the data driven
learning of MLD snooping groups.
Restrictions Only administrator–level users can issue this command.
Example usage:
To enable the data driven learning of an MLD snooping group on the default VLAN:
ES-1210-28/ME:5# config mld_snooping data_driven_learning vlan_name default
state enable
Command: config mld_snooping data_driven_learning vlan_name default state
enable
Success !
DGS-1210-28MP/ME:5#
clear mld_snooping data_driven_group
Purpose To clear the mld snooping data driven group on the Switch.
Syntax
clear mld_snooping data_driven_group [vlan_name <string 32>
| vlanid <vidlist> | all] {<ipv6_addr> | all}
Description
The clear mld_snooping data_driven_group
command used to
clear the mld snooping data driven group on the Switch.
Parameters
vlan_name <string 32> – Clear that the mld snooping applies only to
this previously created VLAN.
vlanid <vidlist> – Clear that
the mld snooping applies only to this
previously created VLAN id.
all – Clear that MLD snooping is to be configured for all VLANs on
the Switch.
{<ipv6_addr> | all} –
Specifies the IPv6 address or all of mld
snooping data driven group to be removed.
Restrictions Only administrator–level users can issue this command.
Example usage:
To clear MLD snooping data driven group:
DGS-1210-28MP/ME:5# clear mld_snooping data_driven_group vlan_name rd1
Command: clear mld_snooping data_driven_group vlan_name rd1
Success.
DGS-1210-28MP/ME:5#
show mld_snooping
Purpose To display mld snooping settings on the Switch.
Syntax
show mld_snooping [vlan_name <string 32> | vlanid <vidlist> |
all]
Description
The show mld snooping
command displays a port from being
defined as a multicast router port by static configuration or by