D-Link DGS-1210/ME series - Enable Snmp Dhcpv6_ Screening Traps; Disable Snmp Dhcpv6_ Screening Traps; Enable Snmp Icmpv6_Ra_All_Node Traps

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
114
enable snmp DHCPv6_ screening traps
Purpose To enable SNMP DHCPv6 screening traps.
Syntax
enable snmp DHCPv6_screening traps
Description
The enable snmp DHCPv6_screening traps
command enables
SNMP DHCPv6 screening traps support on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable SNMP DHCPv6 screening traps support on the Switch:
DGS-1210-28MP/ME:5# enable snmp DHCPv6_screening traps
Command: enable snmp DHCPv6_screening traps
Success.
DGS-1210-28MP/ME:5#
disable snmp DHCPv6_ screening traps
Purpose To disable SNMP DHCPv6 screening traps.
Syntax
disable snmp DHCPv6_screening traps
Description
The disable snmp DHCPv6_screening traps
command enables
SNMP DHCPv6 screening traps support on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable SNMP DHCPv6 screening traps support on the Switch:
DGS-1210-28MP/ME:5# disable snmp DHCPv6_screening traps
Command: disable snmp DHCPv6_screening traps
Success.
DGS-1210-28MP/ME:5#
enable snmp icmpv6_RA_all_node traps
Purpose Used to enable SNMP ICMPv6 RA all-node traps state.
Syntax
enable snmp ICMPv6_RA_all_node traps
Description
The enable snmp ICMPv6_RA_all_node traps command is used
to enable SNMP ICMPv6 RA all-node traps state.
Parameters None.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To enable SNMP ICMPv6 RA all-nodes traps: