DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
236
disable erps
Purpose Used to disable the ERPS function on a switch.
Syntax
disable erps
Description
The disable erps is used to disable the ERPS function on a switch.
Parameters None.
Restrictions Only Administrator, operator and power user-level users can issue
this command.
Example usage:
To disable ERPS:
DGS-1210-28MP/ME:5# disable erps
Command: disable erps
Success.
DGS-1210-28MP/ME:5#
create erps raps_vlan
Purpose Used to create an R-APS VLAN on the switch. Only one R-APS
VLAN should be used to transfer R-APS messages.
Syntax
create erps raps_vlan <vlanid 1-4094>
Description
The create erps raps_vlan is used to create the R-APS VLAN on
the switch. There should be only one R-APS VLAN used to transfer
R-APS messages. Note that the R-
APS VLAN must already have
been created by the create vlan command. This command can only
be issued when this ring is disabled or ERPS is global disabled.
Parameters
<vlanid 1-4094> - Specify the VLAN ID that will be the R-APS VLAN.
Restrictions Only Administrator, operator and power user-level users can issue
this command.
Example usage:
To create an R-APS VLAN with aVLAN ID of 4094:
DGS-1210-28MP/ME:5#DGS-1210-28MP/ME:5# create erps raps_vlan 4094
Command: create erps raps_vlan 4094
Success.
DGS-1210-28MP/ME:5#DGS-1210-28MP/ME:5#
config erps raps_vlan ring_mel
Purpose
Used to configure the ring MEL for an R-APS VLAN.
Syntax
config erps raps_vlan <vlanid 1-4094> ring_mel <value 0-7>
To Next Page
Loading...
