D-Link DGS-1210/ME series - Show Ethernet_Oam Ports

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
310
displayed.
Restrictions None.
Example usage:
To show Ethernet OAM configuration of port 1:
DGS-1210-28MP/ME:5# show ethernet_oam ports 1 configuration
Command: show ethernet_oam ports 1 configuration
Port 1
-----------------------------------------------------------
OAM : Enabled
Mode : Active
Dying Gasp : Enabled
Critical Event : Enabled
Remote Loopback OAMPDU : Processed
Symbol Error
Notify State : Disabled
Window : 1000 milliseconds
Threshold : 100 Errored Symbol
Frame Error
Notify State : Enabled
Window : 1000 milliseconds
Threshold : 1 Errored Frame
Frame Period Error
Notify State : Enabled
Window : 148810 Frames
Threshold : 1 Errored Frame
Frame Seconds Error
Notify State : Enabled
Window : 60000 milliseconds
Threshold : 1 Errored Seconds
DGS-1210-28MP/ME:5#
show ethernet_oam ports
Purpose Used to display for Ethernet OAM statistics.
Syntax
show ethernet_oam ports [<portlist> | all] statistics
Description
The show ethernet_oam ports command is used to
show port’s
Ethernet OAM statistics information.
Parameters
[<portlist> | all] − Specifies a port, a range of ports or all ports to be
displayed.
Restrictions None.