D-Link DGS-1210/ME series - Disable Hol_Prevention; Show Hol_Prevention

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
219
disable hol_prevention
Purpose To disable head of line prevention on the Switch.
Syntax
disable hol_prevention
Description
The disable hol_prevention command is used to disable head of
line prevention on the Switch.
Parameters None.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To disable HOL prevention on the Switch:
DGS-1210-28MP/ME:5# disable hol_prevention
Command: disable hol_prevention
Success.
DGS-1210-28MP/ME:5#
show hol_prevention
Purpose To display head of line prevention state on the Switch.
Syntax
show hol_prevention
Description
The show hol_prevention command is used to display head of line
prevention state on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display HOL prevention on the Switch:
DGS-1210-28MP/ME:5# show hol_prevention
Command: show hol_prevention
Device HOL Prevention State: Enabled.
Success.
DGS-1210-28MP/ME:5#