D-Link DGS-1210/ME series - Download;Upload Commands; Download

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
121
16
DOWNLOAD/UPLOAD COMMANDS
The Download/Upload commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
download
[cfg_fromTFTP [<ipaddr> | <ipv6_addr>] <path_filename 64> config_id <value 1-
2> {increment}] | [firmware_fromTFTP [<ipaddr> | <ipv6_addr>] image_id <value
1-2>]
download
[cfg_fromFTP <ftp_url 256> config_id <vaue 1-2> {increment} |
firmware_fromFTP <ftp_url 256> image_id <value 1-2>]
upload
[[firmware_toTFTP [<ipaddr> | <ip6_addr>] <path_filename 64>] | [cfg_toTFTP
[<ipaddr> | <ip6_addr>] <path_filename 64> config_id <value 1-2>] | [log_toTFTP
[<ipaddr> | <ip6_addr>] <path_filename 64>]]
config configuration
config_id
<value 1-2> [boot_up | delete]
show firmware
information
show config
[current_config | modified | config_in_nvram config_id <value 1-2> {[begin |
include | exclude] <string 80> {<string 80>} {<string 80>}}
config firmware
image_id
<value 1-2> [boot_up | delete]
show boot_file
show firmware
information
Each command is listed in detail, as follows:
download
Purpose To download and install a firmware, boot, or switch configuration file
from a TFTP server.
Syntax
download [cfg_fromTFTP [<ipaddr> | <ipv6_addr>]
<path_filename 64> config_id <value 1-2> {increment}] |
[firmware_fromTFTP [<ipaddr> | <ipv6_addr>] image_id <value
1-2>]
Description
The download
command downloads a firmware, boot, or switch
configuration file from a TFTP server.
Parameters
cfg_fromTFTP − Downloads a switch configuration file from a TFTP
server.
<ipaddr> − The IPv4 address of the TFTP server.
<ipv6_addr> − The IPv6 address of the TFTP server.
<path_filename 64> − The DOS path and filename of the switch
configuration file, up to 64 characters, on the TFTP server. For