DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
37
Command: disable autoimage
Success.
show autoimage
Purpose To display the DHCP automatic image function on the Switch.
Syntax
show autoimage
Description
The disable autoimage command is used to display the DHCP
automatic image function on the Switch.
Parameters
None.
Restrictions None.
Example usage:
To display the DHCP automatic image information on the Switch:
DGS-1210-28MP/ME:5# show autoimage
Command: show autoimage
Autoimage State: Enabled
DGS-1210-28MP/ME:5#
To Next Page
Loading...
