DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
424
57
COMMAND LOGGING COMMANDS
The Command Logging commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
enable command
logging
disable command
logging
show command
logging
Each command is listed in detail, as follows:
Purpose To enable command logging.
Syntax
enable command logging
Description
The enable command logging command is used to enable
command logging.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable the command logging functio:
DGS-1210-28MP/ME:5# enable command logging
Command: enable command logging
Success.
DGS-1210-28MP/ME:5#
disable command logging
Purpose To disable command logging.
Syntax
disable command logging
Description
The disable command logging command is used to disable
command logging.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable the command logging functio:
To Next Page
Loading...
