D-Link DGS-1210/ME series - Erps Force Switch Instance; Erps Manual Switch Instance

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
256
Restrictions Only Administrator, operator and power user-level users can issue
this command.
Example usage:
To clear the instance 3 of ERP on the Switch:
DGS-1210-28MP/ME:5# erps clear instance 3
Command: erps clear instance 3
Success.
DGS-1210-28MP/ME:5#
erps force switch instance
Purpose Used to block an ERP instance port.
Syntax
erps force switch instance <value 1-16> ring_port [west | east]
Description
The erps force switch instance command
forcibly blocks an
instance port immediately after force is configured, irrespective of
whether link failures have occurred.
Parameters
<value 1-16> – Specifies the instance ID to be configured.
ring_port [west | east] – Specified the west or east will be blocked.
Restrictions Only Administrator, operator and power user-level users can issue
this command.
Example usage:
To force the major ring, instance 1, west into blocking:
DGS-1210-28MP/ME:5# erps force switch instance 1 ring_port west
Command: erps force switch instance 1 ring_port west
Success.
DGS-1210-28MP/ME:5#
erps manual switch instance
Purpose Used to configure an instance ring port blocking mode.
Syntax
erps manual switch instance <value 1-16> ring_port [west |
east]
Description
The erps manual switch instance is used to configure an instance
ring port blocking mode.
Parameters
<value 1-16> – Specifies the instance ID.
ring_port [west | east] – Manual ERPS insta
nce westblocked or
eastblocked.
Restrictions Only Administrator, operator and power user-level users can issue
this command.
Example usage: