D-Link DGS-1210/ME series - Gratuitous Arp Commands; Config Gratuitous_Arp Send Ipif_Status_Up

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
143
18
GRATUITOUS ARP COMMANDS
The Gratuitous ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config gratuitous_arp
send ipif_status_up
[enable | disable]
config gratuitous_arp
send dup_ip_detected
[enable | disable]
config gratuitous_arp
learning
[enable | disable]
enable gratuitous_arp
[log | trap]
disable gratuitous_arp
[log | trap]
config gratuitous_arp
log
[enable | disable]
show gratuitous_arp
config gratuitous_arp
send periodically ipif
<ipif_name 12> interval <integer 0-65535>
Each command is listed in detail, as follows:
config gratuitous_arp send ipif_status_up
Purpose Used to enable or disable the sending of g
ratuitous ARP requests
while the IP interface status is up.
Syntax config gratuitous_arp send ipif_status_up [enable | disable]
Description
The config gratuitous_arp send ipif_status_up command is used to
enable or disable the sending of gratuitous ARP r
equest packets
while the IPIF interface is up. This is used to automatically announce
the interface’s IP address to other noDGS. By default, the state is
enabled, and only one gratuitous ARP packet will be broadcast.
Parameters
enable − Enable the sending of gratuitous ARP when the IPIF status
is up.
disable −
Disable the sending of gratuitous ARP when the IPIF
status is up.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable a gratuitous ARP request:
DGS-1210-28MP/ME:5# config gratuitous_arp send ipif_status_up enable
Command: config gratuitous_arp send ipif_status_up enable