D-Link DGS-1210/ME series - Show Mac_Based_Access_Control; Show Mac_Based_Access_Control_Local

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
283
Success.
DGS-1210-28MP/ME:5#
show mac_based_access_control
Purpose To display mac_based_access_control setting.
Syntax
show mac_based_access_control {port [<portlist> | all]}
Description
The show mac_based_access_control command is
used to
display mac_based_access_control settings.
Parameters
port [<portlist> | all] - .Specifies a range of ports or all ports to be
displayed the mac_based_access_control settings.
Restrictions None.
Example usage:
To display MAC-based Access Control settings:
DGS-1210-28MP/ME:5# show mac_based_access_control
Command: show mac_based_access_control
Global State : Enable
Method : Radius
Password : 1234
Trap : Enable
Log : Disable
Max User : 100
Success.
DGS-1210-28MP/ME:5#
show mac_based_access_control_local
Purpose To display mac_based_access_control local database.
Syntax
show mac_based_access_control_local {mac_address
<mac_addr> | vlanid <int 1-4094>}
Description
The show mac_based_access_control_local command is used to
display mac_based_access_control local database.
Parameters
mac_address <mac_addr> - Displays the MAC-based Access
Control local database by this MAC address.
vlanid <int 1-4094> - Displays the MAC-based Access Control local
database by this VLAN ID.
Restrictions None.
Example usage:
To display MAC-based Access Control local database entries:
DGS-1210-28MP/ME:5# show mac_based_access_control_local