D-Link DGS-1210/ME series - Show Poe System

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
169
Description The show poe ports displays the Power over Ethernet (PoE) ports of
the Switch.
Parameters
[all | <portlist>] – Specifies the ports or all ports to be displayed.
Restrictions None.
Example usage:
To display the PoE with ports 8:
DGS-1210-28MP/ME:5# show poe ports 8
Command: show poe ports 8
Port: 8
State : Enable
Priority : Low
Power Limit : Auto
Power(W) : 0.0
Voltage(V) : 0.0
Current(mA) : 0.0
Status : POWER OFF
Time Range : N/A
Success!
DGS-1210-28MP/ME:5#
show poe system
Purpose
Used to display the system information of Power over Ethernet
(PoE).
Syntax
show poe system
Description The show poe system
displays the Power over Ethernet (PoE)
system information of the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the PoE system of Switch:
DGS-1210-28MP/ME:5# show poe system
Command: show poe system
Power Limit : 193
Power Consumption : 0
Power Remained : 0
Power Disconnection Method : Deny Next Port
Detection Legacy PD : Disable