D-Link DGS-1210/ME series - Config Mld_Snooping Mrouter_Ports; Config Mld_Snooping Mrouter_Ports_Forbidden

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
352
Parameters
<vlan_name 32> − Specifies the name of multicast VLAN to be
displayed.
Restrictions None.
Example usage:
To display mld snooping multicast VLAN group:
DGS-1210-28MP/ME:5# show mld_snooping multicast_vlan_group
Command: show mld_snooping multicast_vlan_group
VID Vlan Name IP Range
---- -------------------------------- -----------------------------------------
DGS-1210-28MP/ME:5#
config mld_snooping mrouter_ports
Purpose To enable mld mrouter ports.
Syntax
config mld_snooping mrouter_ports [vlan_name <string 32> |
vlanid <vidlist> | all] [add | delete] <portlist>
Description
The config mld_snooping mrouter_ports command defines a port
that is connected to a multicast router port.
Parameters
vlan_name <string 32> –
specifies that the mld snooping applies
only to this previously created VLAN.
vlanid <vidlist> – specifies that the mld snooping applies only to this
previously created VLAN id.
all – specifies that MLD snooping is to be configured for all VLANs
on the Switch.
add – Adds a specified port to the mld snooping mrouter port.
delete – Deletes a specified port to the mld snooping mrouter port.
<portlist> – Defines the ports to be included from the mld snooping
mrouter group.
Restrictions Only administrator, operator or power user–
level users can issue
this command. Separate non–
consecutive Ethernet ports with a
comma and no spaces; use a hyphen to DGS
ignate a range of
ports. These ports are defined as connected to a multicast router.
Example usage:
To configure mld mrouter ports:
DGS-1210-28MP/ME:5# config mld_snooping mrouter_ports vlanid 1 add 1-3
Command: config mld_snooping mrouter_ports vlanid 1 add 1-3
Success.
DGS-1210-28MP/ME:5#
config mld_snooping mrouter_ports_forbidden
Purpose To define mld mrouter ports forbidden on the Switch.
Syntax
config mld_snooping mrouter_ports_forbidden [vlan_name