D-Link DGS-1210/ME series - Show Radius; Config 802.1 X Fwd_Pdu System

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
376
DGS-1210-28MP/ME:5# config radius 1 ipaddress 10.48.47.11
Command: config radius 1 ipaddress 10.48.47.11
Success.
DGS-1210-28MP/ME:5#
show radius
Purpose To display the current RADIUS configurations on the Switch.
Syntax
show radius
Description
The show radius command displays the current RADIUS
configurations on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display RADIUS settings on the Switch:
DGS-1210-28MP/ME:5# show radius
Command: show radius
Index Ip Address Auth-Port Acct-Port Timeout Retransmit Key
(secs)
----- ---------------- --------- ---------- --------- --------------- ------
1 10.48.74.121 1812 1813 5 10 dlink
Total Entries : 1
Success.
DGS-1210-28MP/ME:5#
config 802.1x fwd_pdu system
Purpose To configure the 802.1x forwarding EAPOL PDU on the Switch.
Syntax
config 802.1x fwd_pdu system [enable | disable]
Description
The config 802.1x fwd_pdu system command is used to configure
the control of forwarding EAPOL PDUs. Then the 802.1x
functionality is disabled, for a port, and if the 802.1x forwarding PDU
is enabled both globally and for the port, a received EAPOL packet
on the port will be flooded on the same VLAN to those ports of which
the 802.1x forwarding PDU is enabled and 802.1x is disabled
(globally or just for the port).
Parameters
[enable | disable] – Specifies the forwarding of EAPOL PDU is
enabled or disabled. The default is disabled.
Restrictions Only Administrator, operator or power user-level users can issue this
command.