DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
388
To enable the SNTP function:
DGS-1210-28MP/ME:5# enable sntp
Command: enable sntp
Success.
DGS-1210-28MP/ME:5#
disable sntp
Purpose To disable SNTP server support.
Syntax
disable sntp
Description
The disable sntp command disables SNTP support.
Parameters None.
Restrictions Only administrator or operator level users can issue this command.
Example usage:
To disable SNTP support:
DGS-1210-28MP/ME:5# disable sntp
Command: disable sntp
Success.
DGS-1210-28MP/ME:5#
Purpose To manually configure system time and date settings.
Syntax
config time <date> <systime>
Description
The config time date command configures the system time and
date settings. These will be overridden if SNTP is configured and
enabled.
Parameters
<date> –Specifies the date, using two numerical characters for the
day of the month, English abbreviation for the name of the month,
and four numerical characters for the year. For example: 19jan2011.
<systime > – Specifies the system time, using the format hh:mm:ss;
that is, two numerical characters each for the hour using a 24-hour
clock, the minute and second. For example: 19:42:30.
Restrictions Only administrator or operate-level users can issue this command.
Manually configured system time and date settings are overridden if
SNTP support is enabled.
Example usage:
To manually set system time and date settings:
To Next Page
Loading...
