D-Link DGS-1210/ME series - Cpu Protection Commands; Enable Cpu_Protect; Disable Cpu_Protect

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
150
20 1
CPU PROTECTION COMMANDS
The CPU Protection commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable cpu_protect
disable cpu_protect
config cpu_protect type { [arp | bpdu | icmp | igmp | snmp]} pps [<value> | no_limit]
show cpu_protect
Each command is listed in detail, as follows:
enable cpu_protect
Purpose To enable the CPU protection function on the Switch.
Syntax
enable cpu_protect
Description
The enable cpu_protect command is used to enable the CPU
protection function on the Switch.
Parameters
None.
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To enable the CPU protection function on the switch:
DGS-1210-28MP/ME:5# enable cpu_protect
Command: enable cpu_protect
Success.
DGS-1210-28MP/ME:5#
disable cpu_protect
Purpose To disable the CPU protection function on the Switch.
Syntax
disable cpu_protect
Description
The disable cpu_protect command is used to disable the CPU
protection function on the Switch.
Parameters
None.
Restrictions Only Administrator or operator–level users can issue this command.
Example usage:
To disable the CPU protection function on the switch: