D-Link DGS-1210/ME series - Clear Address_Binding Dhcp_Snoop Binding_Entry Ports

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
84
Command: show address_binding roaming
Roaming state is enabled.
DES-1210-52/ME:5#
clear address_binding dhcp_snoop binding_entry ports
Purpose Used to clear the DHCP snooping entries learned for the specified
ports.
Syntax
clear address_binding dhcp_snoop binding_entry ports
[<portlist> | all] {all | ipv6}
Description
This clear address_binding dhcp_snoop binding_entry ports
command is used to clear the DHCP snooping entries lea
rned for
the specified ports.
Parameters
[<portlist> | all] –
Specifies a range of ports or all ports to be
configured.
all - Specifies that all entries will be cleared.
ipv6 - Specifies that IPv6 entries will be cleared.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To clear DHCP IPv4 snooping entries on ports 1-3:
DGS-1210-28MP/ME:5# clear address_binding dhcp_snoop binding_entry ports 1-3
Command: clear address_binding dhcp_snoop binding_entry ports 1-3
Success.
DGS-1210-28MP/ME:5#