D-Link DGS-1210/ME series - Dlink Discover Protocol Commands; Enable Ddp; Disable Ddp

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
45
8
DLINK DISCOVER PROTOCOL COMMANDS
The D-Link Discover Protocol commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
enable ddp
disable ddp
config ddp report state [enable | diasble]
config ddp report timer [30 | 60 | 90 | 120]
config ddp ports [all | <portlist>] state [enable | disable]
show ddp
Each command is listed in detail, as follows:
enable ddp
Purpose To enable the D-Link discover protocol function.
Syntax
enable ddp
Description
The enable ddp command is used to enable the D-Link discover
protocol function.
Parameters None.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To enable the D-Link discover protocol function:
DGS-1210-28MP/ME:5# enable ddp
Command: enable ddp
Success.
DGS-1210-28MP/ME:5#
disable ddp
Purpose To disable the D-Link discover protocol function.
Syntax
disable ddp
Description
The disable ddp command is used to disable the D-Link discover
protocol function.
Parameters None.