D-Link DGS-1210/ME series - Show Flash Information

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
127
To display the configuration file and firmware image assigned as a boot up file:
DGS-1210-28MP/ME:5# show boot_file
Command: show boot_file
Bootup Firmware : image_1
Bootup Configuration : config_1
DGS-1210-28MP/ME:5#
show flash information
Purpose
Used to display the flash information of the Switch.
Syntax
show flash information
Description
The show flash information command is used to display the flash
information of the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the flash information of the Switch:
DGS-1210-28MP/ME:5# show flash information
Command: show flash information
Flash ID : MX25L25635E
Flash size : 32MB
Partition Used Available Use%
Boot 1310720 0 0
Image1 12357664 1798112 87
Image2 12337184 1818592 87
FileSystem 331776 3600384 8
DGS-1210-28MP/ME:5# show flash information